- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
VLAN Configuration in CLI on Netgear M4100-26G
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
VLAN Configuration in CLI on Netgear M4100-26G
I bought a M4100 Second hand and I want to configure some Access and Trunk ports on it. I come from the Cisco line of Switches from work so I know how to configure them there. But The Netgear CLI seems very different and unintuitive for me.
How would I go about configuring an Acessport onto a range of interfaces?
I have seen you can select several interfaces just with the interface command, and how woudl I then configure them?
With Acessports for VLANs, I want them to Filter ingress traffic for untagged only, the same for egress, but where do I actually tell the Interface which VLAN to tagg the incomming packets with inside the switch?
For trunkports I probably want to filter for tagged only traffic for ingress and egress but also here I am not sure where to configure the allowed vlans?
Any help would be appriciated.