- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
unable to get CAM Table from GSM7252PS
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm unable to get the CAM Table via snmp(dot1dTpFdbTable). Other snmp queries work. public@vlan doesn't work either.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Simon1978,
Welcome to the community!
Please use MIB node 'dot1qtpFdbTable' instead.
Regards,
EricZ
NETGEAR employee
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Simon1978,
Welcome to the community!
Please use MIB node 'dot1qtpFdbTable' instead.
Regards,
EricZ
NETGEAR employee
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: unable to get CAM Table from GSM7252PS
Hi,
Thanks for the tip! The index-value in that table was confusing at first. But now I get it. The first value is the vlan number and the following numbers are the mac-address in decimal.
Regards,
Simon
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: unable to get CAM Table from GSM7252PS
Hi Simon1978,
Correct!
With regard to resolve your problem, I encourage you to mark the appropriate reply as the “Accepted Solution” so others can be confident in benefiting from the solution. The NETGEAR Community looks forward to hearing from you and being a helpful resource in the future!
Regards,
EricZ
NETGEAR Employee