× Introducing the Orbi 970 Series Mesh System with WiFi 7 technology. For more information visit the NETGEAR Press Room.
Nighthawk M6 Pro Unlocked Hotspot 5G mmWave
Reply

Re: NETGEAR MR2100

khaled10
Tutor

NETGEAR MR2100

The device stops on the Net Gear logo and turns off

Removing the battery did not work
Attempt by cable directly without battery did not work
And also with the battery it did not work

Repeat this several unsuccessful attempt.

leave the device for a day, a week, and a month.

 

NETGEAR MR2100

Model: MR 2100

Firmware: NTGX24_10.17.08.00

Modem Version: SDX24_10.25.00.06

GUI Version: MR2100-100EUS_04.02.171.00

PRI Version: 05.04
Firmware Build Date 2020/08/21

 

 

Model: MR2100|Mobiler Router Nighthawk M2
Message 1 of 10

Accepted Solutions
khaled10
Tutor

Re: NETGEAR MR2100

Yes
There is no response.

View solution in original post

Message 4 of 10

All Replies
khaled10
Tutor

Re: NETGEAR MR2100

UP
Message 2 of 10
Transfluxor
Apprentice

Re: NETGEAR MR2100

Did you press the reset button?

Message 3 of 10
khaled10
Tutor

Re: NETGEAR MR2100

Yes
There is no response.
Message 4 of 10
khaled10
Tutor

Re: NETGEAR MR2100

As shown in the picture, it restarts automatically. Is
there another solution?
Message 5 of 10
khaled10
Tutor

Re: NETGEAR MR2100

UP
Message 6 of 10
khaled10
Tutor

Re: NETGEAR MR2100

UP
Message 7 of 10
khaled10
Tutor

Re: NETGEAR MR2100

UP
Message 8 of 10
Transfluxor
Apprentice

Re: NETGEAR MR2100

It is not clear what answer you want to get - if your router does not start with and without a battery, and does not start from the reset button ...
It's simple - an exchange or a service center if the router is under warranty, or a service center or throw it away if not under warranty.
If you have good knowledge of electronics, then you can try to look inside the router for ports for flashing or a diagnostic port (COM) to see if the router is alive or not. If the EPROM is installed separately on the board, then you can flash the firmware into the new EPROM and re-solder it. But this is your responsibility. I myself did not disassemble this router so I can't help.
Now the firmware for this router has been removed from free access, but earlier they were available so that they could be saved by some of the users - you can ask around on this forum.

Message 9 of 10
khaled10
Tutor

Re: NETGEAR MR2100

Service center in another country.
The router cannot be sent due to a ban to prevent the spread of Corona virus.

 

 

The answer I'm looking for?

Who happened to have the problem and solved it,

what is the solution?
Who has the firmware to install?

 

Message 10 of 10
Top Contributors
Discussion stats
  • 9 replies
  • 2868 views
  • 1 kudo
  • 2 in conversation
Announcements

Orbi WiFi 7