Nighthawk M1 (MR1100EUS) DMZ not working on latest firmware

[turbolooser]

Dear Netgear Support and others trying to help 🙂

I am running the MR1100 with a public ipv4 address associated to a dyndns record but DMZ enabled does not allow any access on any service hosted behind the MR1100. When enabling a single port in port forwarding (e.g. port tcp 22) then I can access that 1 service from external but this is not the intention when using a DMZ.

I have already reset the device once using the webui but might wanna do it again using the hardware button.

Any other ideas?

And please note that I am IT professional so do not botehr me with the usual "Hav you tried to turn it off and on again" replies.
Thanks so much

Thomas

[Wendi221 · Accepted solution]

---

@turbolooser wrote:

seems to work again. Thanks

---

Me Too, trying again.

[turbolooser]

Noone with the same issue? 

[schumaku]

@Blanca_O please.

@turbolooser latest firmware is not very informative.

[turbolooser]

firmware: 12.06.03

see attachment

[Blanca_O]

Hi turbolooser, 

A new firmware was released for MR1100. Kindly check for an available firmware update. 

Firmware version: NTG9X50C_12.06.07.00

Regards, 
Blanca 
Community Team

[turbolooser]

seems to work again. Thanks

[Wendi221 · Accepted solution]

---

@turbolooser wrote:

seems to work again. Thanks

---

Me Too, trying again.