not broadcasting wifi mr2100

[rookwood52]

hi, mr2100 router is not broadcasting wifi again today, though it is providing good internet access via the ethernet socket to my PC's. On the touchscreen it shows  a X through the wifi emblem. Has done this before a couple of times in the last 2 months but rebooting worked, today wifi  does not work, nor switching off for several minutes

tapping or holding down the wifi emblem has no effect on the large X over the emblem, other than bring up the "battery fully charged" page that rapidly swamps everything else, even though it was disconnected from the power lead 2 hours ago. Its 7 months old. I have have made sure the wifi timer is "never off"

[Blanca_O · Accepted solution]

Hi @rookwood52

Welcome to NETGEAR Community!

Please provide the device SKU (MR2100-xxxxx) and firmware version. 

If issue re-occur, please access MR1100 settings page, go to Settings > Wireless > "Broadcast Wi-Fi Name SSID" should be checked. 

Kindly check as well if WiFI Standby is set to Disabled or Enabled. 

Regards,
Blanca
Community Team

[Blanca_O · Accepted solution]

Hi @rookwood52

Welcome to NETGEAR Community!

Please provide the device SKU (MR2100-xxxxx) and firmware version. 

If issue re-occur, please access MR1100 settings page, go to Settings > Wireless > "Broadcast Wi-Fi Name SSID" should be checked. 

Kindly check as well if WiFI Standby is set to Disabled or Enabled. 

Regards,
Blanca
Community Team