- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Power On ReadNAS 422 and reboots...
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Power On ReadNAS 422 and reboots...
Hello all,
Power On my RN422 and after 30 seconds it reboots and then fully boots up. Also have a RN524 doing the same but after two reboot it fully boots up. Other then that they both work fine. I updated the firmware to 6.10.9 but no change. Checked the fan and power supply too.
Anyone else experienced this issue?
Thx.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Power On ReadNAS 422 and reboots...
@FerociousNAS wrote:
Power On my RN422 and after 30 seconds it reboots and then fully boots up. Also have a RN524 doing the same but after two reboot it fully boots up. Other then that they both work fine. I updated the firmware to 6.10.9 but no change. Checked the fan and power supply too.
Anyone else experienced this issue?
Odd. Download the log zip files, and see if you can figure out what is happening. Maybe start by looking in dmesg.log.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Power On ReadNAS 422 and reboots...
Thank but the logs show no errors.... 🤔
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Power On ReadNAS 422 and reboots...
@FerociousNAS wrote:
Thank but the logs show no errors.... 🤔
You should be seeing something in the log zip around the time of the second reboot.
FWIW, I am not seeing this behavior in my own ReadyNAS.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Power On ReadNAS 422 and reboots...
ok I got the zip log file this time.... Looked at the dmes.log. Not really sure what I'm looking for? 🤔
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Power On ReadNAS 422 and reboots...
How are you shutting down the NAS?
The errors in dmesg indicate that the volume is resyncing and also that the usb drive was not properly unmounted. So I am wondering if you doing a clean shutdown when you power down the NAS.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Power On ReadNAS 422 and reboots...
Issue seems to be resolved. I replaced the dead CMOS CR2032 battery and let the HDD sync up. Unplugged the power and flushed the flee power by holding down the power button for 10 sec, plugged power brick pack in and started up w/o the multiple reboots. I will leave it unplugged for a few hrs and report back.
Thanks for the help! 🙂