- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: rn526 cant access it via admin anymore
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
rn526 cant access it via admin anymore
Hi
Did a upgrade to 6.10.4 and rebooted
I can see it appears in the switch ang gets ip , but i cant reach the nas at all
dosent responds to ping , did a second restart of the nas , same thing ??
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: rn526 cant access it via admin anymore
@dunkens wrote:
I can see it appears in the switch ang gets ip , but i cant reach the nas at all
- Are you saying that you can't reach the admin page, or that you can't access the shares in Windows Explorer/Finder (or both)?
- What status are you seeing on the LCD?
Have you tried installing RAIDar? It might give you more status information. https://kb.netgear.com/20684/ReadyNAS-Downloads
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: rn526 cant access it via admin anymore
Hi
Couldnt access it at all ...
Did found a way , did remove the network cable and inserted it again , then it did work
Wierd , but it works 🙂
Never had any issues before with upgrading the nas
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: rn526 cant access it via admin anymore
Is it possible that something else on the network was assigned the same IP address? How is your NAS IP address assigned, DHCP (with or without address reservation in the router) or static?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: rn526 cant access it via admin anymore
Hi
Nas is using static ip , it feels like the nic interface went hayway somehow ..
But glad its working as it should :))
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: rn526 cant access it via admin anymore
If you are using a static IP (which is not really the best way to do it), make sure that address is outside the range of assignments by DHCP or that you also reserve it in the router (which negates the need for the static IP). Otherwise, the router might assign that address to another device as well if the NAS is off at the time, and the NAS will not communicate properly.
Address reservation in the router is typically a better way to go. That way, if you change routers and the new one uses a different subnet from the old, you don't have to figure out how to get into the NAS GUI to change it's address.