Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
How do I connect to the readyNAS to view or change it's configuration
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2017-12-13
11:49 AM
2017-12-13
11:49 AM
How do I connect to the readyNAS to view or change it's configuration
I have an old ReadyNAS which I need to point some backups too. I beleive it was previoulsy configured but it's been unplugged and off the network for a while. I see there is nowhere to connect a console cable or a monitor too. I plugged in a ethernet cable and it has a link light. Now without knowing the current config info how do I connect to the device to view or chance it's configuration? I tried the RAIDar software but it can't find it on the network.
Model: ReadyNAS RNRX4410|ReadyNAS 2100
Message 1 of 2
Labels:
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2017-12-13
12:57 PM
2017-12-13
12:57 PM
Re: How do I connect to the readyNAS to view or change it's configuration
RAIDar is the right tool. You might try the 4.3.8 version instead of the newer OS 6 version. https://kb.netgear.com/20684/ReadyNAS-Downloads#raidar
If you are prepared to rebuild it, perhaps just do a factory reset and then look for it with RAIDar.
This is a Readynas 2100?
Message 2 of 2