- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
MR60 with blue light while MS60 with amber light
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good afternoon. After a recent power outage the mesh came back on but I noticed the router has a steady blue light while the satelites have a steady amber light. On the Netgear app Network Map, the router shows a green dot while the satelites show a magenta dot. On the app the satelites wont show an IP adress or firmware version. When I wifi connect or cable connect my laptop the connection shows as unrecognized. What's the problem here?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello jjgonzalezh,
May you factory reset your Nighthawk Mesh system by holding down on the reset button for 15+ seconds using a pin/needle. You will need to run through the setup assistant again and you may do so using the Nighthawk app.
Regards,
Christian
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello jjgonzalezh,
May you factory reset your Nighthawk Mesh system by holding down on the reset button for 15+ seconds using a pin/needle. You will need to run through the setup assistant again and you may do so using the Nighthawk app.
Regards,
Christian
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: MR60 with blue light while MS60 with amber light
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more