× Introducing the Orbi 970 Series Mesh System with WiFi 7 technology. For more information visit the NETGEAR Press Room.
Orbi WiFi 7 RBE973
Reply

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

Himaro0
Aspirant

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

Hello,

 

Still getting QOS error: device not found 

 

Things tried:

Downgrade back to version .130 and did a hard reset, upgraded to version .134

 

The connection benchmark does not match the actual number IPS speed number. 

 

Any thoughts? 

 

Thanks

Message 51 of 57
Netduma-Liam
NetDuma Partner

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

Could you please repeat the process but instead downgrade to the 114 firmware, linked below.

https://kb.netgear.com/000062867/XR500-Firmware-Version-2-3-2-114

Once downgraded factory reset either through the interface or by holding the button on the back for thirty seconds.

 

Then re-upgrade and don't factory reset after the upgrade.

Message 52 of 57
domino138
Guide

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

Hi Liam - do you have any idea when the next version is coming out for the XR500 please?

Message 53 of 57
Netduma-Fraser
NetDuma Partner

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

@domino138 we post any and all potential updates on the status of firmware here: http://support.netduma.com/en/support/solutions/articles/16000132677-dumaos-firmware-progress outside of that we don't have any extra information to give
Message 54 of 57
lenbo7777
Tutor

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

My XR500 had a problem - documented here:

...where it would sporadically restart and reset.  Since upgrading to .134, I haven't experienced this again.  But I also hadn't reserved any addresses.  Earlier this week, I reserved one device and address in the LAN.  My DHCP is set to 192.168.1.2 - 254.

 

The morning after I made the reservation, my router restarted and reset - just like it had previously.  

 

Is anyone else experiencing this...and is there ever going to be any relief?

Message 55 of 57
FURRYe38
Guru

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

I recommend that you leave the DHCP IP address pool range set to a smaller range. You don't have to use the default range. I personally never use the factory range on any NG router. Also this provides room for static IP addressed devices as well. I use .100 to .150 as I only have around 30 devices. Plenty of room for additional devices if and when that happens. 

 

We hope so, however don't have that info. 

Message 56 of 57
Netduma-Liam
NetDuma Partner

Re: New - XR450/XR500 Firmware Version 2.3.2.134 Released

That is odd, I would suggest going through and reserving IP addresses outside the DHCP range, then see if you experience any further disconnections after that.

Message 57 of 57
Discussion stats
  • 56 replies
  • 13928 views
  • 11 kudos
  • 14 in conversation
Announcements

Orbi WiFi 7