On the right hand side on traffic analytics all the settings still show even though on the left there is nothing because the xr500 has been factory reset and there should be nothing there, so i tried to add a new rule and then added devices to this rule and set the times and clicked ok but in the rules section nothing shows up so i cannot disable or enable something that is not there but in the analytics section it shows up, only way to then stop that rule is to disable all rules but this is absolutely useless as i need to alter the times, i searched this up on the internet and the same problem exactly the same cropped up in august last year with the customer being asked if they had deleted a device off of the router that can cause this, now that question is absurd, when you factory reset all devices are deleted off of it, basically it seems like the way this firmware was written is flawed and once you hard reset or factory reset this function is then broken forever, would be really nice if someone from netgear could give a heads up on when this will be fixed as it is now useless for stopping my kids devices at certain times.
