Reply

XR700 and S8000 Set up settings

bmguidry
Tutor

XR700 and S8000 Set up settings

I am going to be setting up a XR700 with a S8000. Are there any specific settings I need to change for this to work properly or is it just plug and go? Set up will be Modem to XR700 to S8000.

Message 1 of 6
FURRYe38
Guru

Re: XR700 and S8000 Set up settings

What is the Mfr and model# of the ISP modem the NG router is connected too?

 

The S8000 also has QoS I believe. It's recommended to use either the QoS features on the XR router or the S8000 switch however not at the same time. 

 

Review this for optimal settings:

http://support.netduma.com/support/solutions/folders/16000090646

 

My Setup (Cable 1Gbps/50Mbps)>CAX80 v2.1.2.1(LAG Disabled)>RBK853 v4.6.3.16
Additional NG HW: C7800/CM1100/CM1200CM2000, Orbi CBK40, CBR750, RBK50(v22), SXR30(v110), R7000(v34), R7800(v84), R7960P(v82), EX7500/EX7700, XR450(v120) and WNHDE111
Message 2 of 6
bmguidry
Tutor

Re: XR700 and S8000 Set up settings

It will connect to a Pace 5286AC. I have a fiber ont. I have to use the Pace 5286AC as it controls my cable TV as well unfortunately.

Message 3 of 6
FURRYe38
Guru

Re: XR700 and S8000 Set up settings

Regarding modem router combo units, Couple of options,
1. Configure the modem for transparent bridge mode. Then use the NG router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the NG router gets from the modem. <I believe you'll need to configure this option. 

My Setup (Cable 1Gbps/50Mbps)>CAX80 v2.1.2.1(LAG Disabled)>RBK853 v4.6.3.16
Additional NG HW: C7800/CM1100/CM1200CM2000, Orbi CBK40, CBR750, RBK50(v22), SXR30(v110), R7000(v34), R7800(v84), R7960P(v82), EX7500/EX7700, XR450(v120) and WNHDE111
Message 4 of 6
bmguidry
Tutor

Re: XR700 and S8000 Set up settings

Yes the Pace 5286 does require the DMZ option. I have been through solving that issue before. Thanks for your help. 

Message 5 of 6
FURRYe38
Guru

Re: XR700 and S8000 Set up settings

Enjoy. Smiley Wink

My Setup (Cable 1Gbps/50Mbps)>CAX80 v2.1.2.1(LAG Disabled)>RBK853 v4.6.3.16
Additional NG HW: C7800/CM1100/CM1200CM2000, Orbi CBK40, CBR750, RBK50(v22), SXR30(v110), R7000(v34), R7800(v84), R7960P(v82), EX7500/EX7700, XR450(v120) and WNHDE111
Message 6 of 6
Discussion stats
  • 5 replies
  • 683 views
  • 1 kudo
  • 2 in conversation
Announcements