× Introducing the Orbi 970 Series Mesh System with WiFi 7 technology. For more information visit the NETGEAR Press Room.
Orbi WiFi 7 RBE973
Reply

Nighthawk RAX200 - ethernet port becomes disabled randomly

hwoeurtl1
Follower

Nighthawk RAX200 - ethernet port becomes disabled randomly

Using the Nighthawk RAX200 with Firmware Version V1.0.4.120_1.0.61

 

Randomly, perhaps every few days or so, any of the ethernet ports on the back of RAX200 become disabled, meaning I can't access the internet through the device on that port. when I connect a device through that port once it has become disabled, my device can recognize, assign itself an IP address but cannot connect to the internet. The device does not show up when I go to routerlogin.com and check Attached Devices for the right device. However, the port light illuminates, which indicates there is at least a physical connection. 

As soon as I restart the router, the issue goes away only to randomly come back at some point later.

 

How do I get ports on the back of the router to not randomly disable? 

Model: RAX200|Nighthawk Tri-band AX12 12-Stream Wi-Fi 6 Router
Message 1 of 2
antinode
Guru

Re: Nighthawk RAX200 - ethernet port becomes disabled randomly

> [...] any of the ethernet ports on the back of RAX200 become disabled,
> meaning I can't access the internet through the device on that port.
> [...]

 

   Does that mean that one of the ports fails at a time, unrelated to
which device is connected to it?  Other ports continue to work?

 

   Do wireless device connections also fail when this happens?  What all
fails when one failure is detected.

 

> [...] when I connect a device through that port once it has become
> disabled, my device can recognize, assign itself an IP address but
> cannot connect to the internet. [...]

 

   Does "assign itself an IP address" mean that your (unspecified) "a
device" got a self-assigned address in the "169.254.x.y" range?  That
would suggest that the device can't communicate with router's DHCP
server.


> How do I get ports on the back of the router to not randomly disable?


   Blame assignment is Job One.  Test/swap cables.  Move devices to
different ports.  Observe/record which devices fail when connected
where.

 

   I wouldn't expect a single port to fail to communicate on its own,
especially if its port-status LED is still good, and then recover with a
router restart.  Bad hardware is always a possibility, however.

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 799 views
  • 0 kudos
  • 2 in conversation
Announcements

Orbi WiFi 7