RAX80 Firmware Version 1.0.3.102 Link aggregation Not working

[The-Ark]

After update RAX80 Firmware  to Version 1.0.3.102

Link aggregation Not working anymore

Can not connect to my network device using Link aggregation.

I will have to roll back to Version 1.0.2.76.

Any one know how to fix Link aggregation on new firmware?

[plemans]

After the update/issue did you try a factory reset? 

If an old setting is causing an issue, many times a reset after firmware changes can fix it. 

[The-Ark]

I did a factory reset.
Still can not use Link aggregat

I believe its firmware issue

[jcax]

No idea if this following will help you address your issue, but I hope so.

I have upgraded from build 99 to 102. Had a bit of trouble.

I had link aggregation working with my NAS on 99, but had trouble getting the upgrade to 102 to succeed. It kept failing with error on updating language table (see this post https://community.netgear.com/t5/Nighthawk-Routers-with-WiFi-6-AX/RAX80-New-Firmware-Out-Today/m-p/1....

I tried doing a factory reset on 99. After that the 102 was successfully installed as part of the initialization process.

Note that I had my NAS shut down during this whole process.

I updated configuration of RAX80 to turn on link aggregation. Restarted the NAS. Link aggregation reestablished successfully.

[The-Ark]

Thank you

     Your solution works.

1. I roll back Version 1.0.2.76 & factory reset. (shut down all network devices~)

2. update firmware Manually to Version 1.0.3.102

3. Manually setup all setting.

4. Turn all network devices back on.

Everything works. (Link aggregation , Port fowarding, DDNS.)

I will still call it a bug.

It is very complicated update process.

Netgear will get a lot of complains for Router act broken.

[jcax]

---

@The-Ark wrote:

Thank you

     Your solution works.

---

Happy to help. Glad you got it working.