Reply

Re: Security Access Control is out of control after devices over 20-30

HowardLu
Aspirant

Security Access Control is out of control after devices over 20-30

Hi, Netgear:

 

I met big problem about access control when it is turned on.

 

I turned on access control, and checked "Block all new devices from connecting"

Block function is worked, but after 20 - 30 clients connected, I make some clients to "allowed". but it cannot be "allowed", and when I reboot device, some "ever allowed" clients change to blocked. and I also observed the access control menu is always refreshing and become slower, very hard to show this page.

When saw this symptom , I found another issues is that all buttons cannot be controled. 

 

To fix this problem, I need to factory reset to make it recover, but when all clients are relogin, this symptom is happened again.

 

Please kindly fix it, I listed device info here.

Hardware VersionR1.05
Firmware VersionV1.0.3.80_1.0.1
GUI Language VersionV1.0.3.80_1.0.0.14

 

Thanks,

Howard.

 

 

Model: RAX40|Nighthawk AX4 4-Stream WiFi Router
Message 1 of 3
Christian_R
NETGEAR Employee Retired

Re: Security Access Control is out of control after devices over 20-30

Hi Howard, 

 

May you revert to the previous firmware version and let us know if your issue persists.

 

https://kb.netgear.com/000061392/RAX40-Firmware-Version-1-0-3-64

 

Christian 

Message 2 of 3
HowardLu
Aspirant

Re: Security Access Control is out of control after devices over 20-30

Hi, Christian:

 

Thanks a lot,

But when I roll back to V1.0.3.64,   WIFI function become unstable, it continued to ON and OFF automaticaly.

Need to use latest firmware to make WIFI worked.

 

BR,

Howard.

Message 3 of 3
Top Contributors
Discussion stats
  • 2 replies
  • 313 views
  • 0 kudos
  • 2 in conversation
Announcements