AC3200 R8000 TFTP Doesn't Work for Corrupted Firmware

[NadL]

Hi,

The power light is blinking-white.
I followed the TFTP procedure but when turning the router back on, the light goes directly to blinking-white, not blinking-amber, which doesn't allow me to upload the FW.
I also tried to reset, including 30-30-30, but nothing helped and the light just goes directly to blinking-white and the TFTP "put" gets a "time out" every time.

Any advice?

Thanks

[FURRYe38]

Need to press the reset button for 30 seconds then release, then it send to PUT the command and upload the FW. 
Make sure you enable tftp: https://www.thewindowsclub.com/enable-tftp-windows-10
Video walk through using a tftp client. Use the built in one for windows 10 though. the video is more of an example of how its done:
https://www.youtube.com/watch?v=R9DLrLQrpaw
I had a problem on a Windows 10 PC where this didn't work to use TFTP, so I switched to a WIndows 7 PC and the TFTP worked.

Try nmrpflash as well:

https://community.netgear.com/t5/Nighthawk-WiFi-Routers/R7960p-Router-will-not-update-firmware/m-p/2...

IF the router isn't responding too or getting to the TFTP Mode then possible the router is toast and needs replacing.