NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
How to access R7000 when set as an access point?
I just set up my "old" R7000 as an access point to extend the wifi reach of my R8000. Just so we are clear. IT WORKS. I am able to connect to the R7000 wifi and get to the internet. The is...
Sadly this is not the case. None of the devices connected to the wireless access point (R7000) show up on the "connected" device list.
I do not mind this if I can connect to the R7000 (which of course I do not seem to be able to)
I think I have come up with a "Work Around"
I connected a laptop directly to the R7000 and logged in and enabled the "Remote Management" Option
With that enabled I can login the router and see what is connected to it.
> I connected a laptop directly to the R7000 and logged in and enabled
> the "Remote Management" OptionThat would suggest that you haven't actually 'set up [your] "old"
R7000 as an access point', because, if you had, then that feature would
be disabled.So, what you _actually_ did is a mystery. That includes what you
connected to what, and how you configured anything. (Hint: If a device
has different types of ports, then "connected to device" is not enough
detail.)It might be educational to compare the IP addresses of devices which
are connected to your R7000 with those of devices which are connected to
your R8000. Those would all be on the same subnet if the R7000 were
actually configured as a WAP.
Visit http://netgear.com/support , put in your model number, and look
for Documentation. Get the User Manual (at least). Read. Look for
"Set Up the Router as a WiFi Access Point".
> I think I have come up with a "Work Around"If you actually had done what you said you had done, then there'd be
nothing to work around. If all you did was to cascade two NAT routers,
then there might be more to work around than you've yet discovered.> With that enabled I can login the router [...]
How, exactly?