I can't access the configuration page

---

mandfl wrote:

As default, the IP address for entering the panel should be 192.168.0.100 but when I try to connect to it I can't get any connection. It loads for like one minute and then says it cannot reach the website.

 

I also tried download the app Nighthawk, it does not detect the Router even if I'm connected to it. If I try using the IP 192.168.1.1 i get into the Modem TIM webpage and I cannot do any change to the Netgear router from there.

 

Does the Nighthawk app support the WNDAP360? I see no mention in the manual for this device.

Which products support the NETGEAR Nighthawk app? | Answer | NETGEAR Support

---

mandfl wrote:

All my WiFi devices can connect to the Router, so it works but in any on them I cannot access the control panel.

As default, the IP address for entering the panel should be 192.168.0.100 but when I try to connect to it I can't get any connection. It loads for like one minute and then says it cannot reach the website.

 

---

Which router? The WNDAP360 ios a wireless access ppint. It needs to be connected to a router.

You might get more help, and find earlier questions and answers specific to your device, in the appropriate section for your hardware. That's probably here:

Business Wireless - NETGEAR Communities

In the meantime you could visit the support pages:

Support | NETGEAR

Feed in your model number and check the documentation for your hardware. Look at the label on the device for the model number.

You may have done this already. I can't tell from your message.

I mention it because Netgear stopped supplying printed manuals and CD versions some years ago and people sometimes miss the downloads.