- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: R7000P - Can't Disable Remote Management
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
R7000P - Can't Disable Remote Management
Firmware: V1.3.3.142_10.1.75
Cannot disable remote mgmt under Advanced/Advanced Setup/Web Services Management
I uncheck the Turn on Remote Management box and click Apply. It returns checked.
Also cannot change the port # or the IP Address selections (Everyone/Range/Only This Computer). I can toggle the HTTPS requirement box.
Only using this as a router. WIFI is disabled.
I upgraded to the latest firmware (above) because of stability issues. Defaulted it and manually reconfigured after the upgrade. Not sure if I enabled remote mgmt after the upgrade, but need it disabled for a PCI scan now.
Anyone else seeing this?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: R7000P - Can't Disable Remote Management
Has a factory reset and setup from scratch been performed since last FW update?
Try a different browser?
Is the Nighthawk app connected to the router?
My Setup | ISP SparkLight | Internet Cable 1000↓/50↑ CAX30 Gateway Mode | Wifi Router and RBK853 | Switches NG GS105/8, GS308v3, GS110MX and XS505M |
Additional NG HW: C7800/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: MK63, R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX50v2, XR450/500/700/1000, EX7500/EX7700
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: R7000P - Can't Disable Remote Management
Factory default after firmware upgrade - Yes.
Tried Chrome/FF/Edge/IE11. Didn't make any difference. None allowed the change.
Not onsite so the Nighthawk app is useless.
Thanks