MR60

[AH_1876]

Bij het opstarten/updaten van de MR60 werd de internetverbinding onderbroken. Nu blijft de LED wit knipperen. De voeding verwijderen en opnieuw aansluiten bracht geen oplossing. De resetknop achteraan 7 seconden indrukken en heropstarten bracht geen oplossing. Ik kan geen verbinding maken met de router om handmatig de firmware te herstellen. wie kan me helpen ?

TRANSLATION : The internet connection was interrupted when starting/updating the MR60. Now the LED continues to flash white. Removing the power supply and reconnecting it did not solve the problem. Pressing the reset button at the back for 7 seconds and restarting did not solve the problem. I cannot connect to the router to manually restore the firmware. Who can help me

[michaelkenward]

There is more severe, recovery reset, that you could try:

• Press reset for 30 seconds
• Keep pressing reset while removing power
• Keep pressing reset for another 30 seconds while apply power

If that fails, you are into TFTP country.

How to upload firmware to a NETGEAR router using Windows TFTP | Answer | NETGEAR Support

This isn't the easiest operation, so if you are forced to use it, you could try a web search to find videos that guide you through the process.

[FURRYe38]

Any progress on this? 

What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6 is recommended. 

---

@AH_1876 wrote:

TRANSLATION : The internet connection was interrupted when starting/updating the MR60. Now the LED continues to flash white. Removing the power supply and reconnecting it did not solve the problem. Pressing the reset button at the back for 7 seconds and restarting did not solve the problem. I cannot connect to the router to manually restore the firmware. Who can help me

---