New Features and Enhancements: 11/11/2021

Supports Smart Parental Controls (SPC)
Fixed AirPlay issue while iPhone/iPad and Apple TV are connected to the same node, either MR60 or MS60.
Fixed security issues.

Download Link:

MR60 (Mesh Router): https://www.downloads.netgear.com/files/GDC/MK62/MR60-V1.1.6.122_2.0.58.zip

MS60 (Mesh Satellite): https://www.downloads.netgear.com/files/GDC/MK62/MS60-V1.1.6.122_2.0.58.zip

Installation Instructions:

Download the firmware to a convenient place such as your desktop.
Log in to the router using http://routerlogin.net
Click the ADVANCED tab.
Click Administration.
Click Router Update.
Click the Manual Update tab.
Select satellite first and a new web page pops up. Please browse the new satellite firmware and upgrade satellite firmware first.
After you finish the satellite firmware upgrade, please find “Locate and select the upgrade file on your disk” on the MR60 web GUI and click “Browse” and locate the file you just downloaded.
Click Upload. While the firmware is loading, do not interrupt the upgrade process.
The router reboots when the upgrade is complete.

After the router boots up and the LED becomes steady blue.

To check that the upgrade was successful, log in to the router again at http://routerlogin.net and check the firmware version.

Note: If a problem is seen after applying this FW update, try powering OFF the ISP modem, MR and MS units for 1 minute then back ON. Last resort would be to try a full on Factory Reset and setup from scratch.

This article applies to:

Nighthawk WiFi Systems (7)
- MK62
- MK63
- MK63S
- MK64
- MK6W
- MR60
- MS60

Let us know how it works for you...

Forum Discussion

New - MK6x series: MR60 / MS60 FW v1.1.6.122 Released