Reply
Highlighted
Aspirant

After update

After updating the router I can not access the router and I can not reset the factory settings.

Model: R7800|Nighthawk X4S AC2600 WiFi Router
Message 1 of 8
Highlighted
Apprentice

Re: After update

OK.  You will need more divulge more information for us to understand the problem(s).  How are you trying to access the router...  telepathically or via more traditonal methods such as routerlogin.net or 192.168.0.1/192.168.1.1?  In the app or browser?  What happens after you reset the router???  Is the SSID boradcasting etc...

 

Message 2 of 8
Highlighted
Master

Re: After update

What are the light of the router doing?

 

Message 3 of 8
Highlighted
Aspirant

Re: After update

I update router from the app to the last update , but after that I cannot find the Wi-Fi Signal or when I connected it to ethernet cannot access router setting.
Message 4 of 8
Highlighted
Aspirant

Re: After update

blink orange
Message 5 of 8
Highlighted
Master

Re: After update

Sounds like the firmware update went wrong and now the router can not boot fully, do you know to do a ipcomfig in the command prompt window of windows if you run windows on your computer you will need to connected via a lan cable to the router?

If you can find what ip address router is putting out you may tffp into the router and reflash it with new firmware, this time do it with the app you used before.

 

Message 6 of 8
Highlighted
Aspirant

Re: After update

 
Message 7 of 8
Highlighted
Aspirant

Re: After update

12.PNG

Message 8 of 8
Top Contributors
Discussion stats
  • 7 replies
  • 377 views
  • 0 kudos
  • 3 in conversation
Announcements