D7000v2 NBN Setup for HFC on Belong

[Parker_021]

Hey guys i have been banging my head against a wall trying to work out the proper settings for my D7000v2 to connect to my HFC NBN. The NBN comes in through a Arris CM8200B P2

Here are my current setting and looking for any tips that might make it work.

Thanks guys

[antinode]

> [...] The NBN comes in through a Arris CM8200B P2

   A cable modem.  So why are you fiddling around with DSL settings?
And the VLAN/Bridge stuff?  At least one of us is confused.

   Are you following some set of instructions?  If not, then if I were
dealing with a cable modem (and cable-TV-type ISP), I'd normally just
reset the settings on the D7000v2, attach its "LAN 4 / Ethernet WAN"
port", and hope for the best.

   "Must use Ethernet WAN" should be harmless, possibly even helpful.
Why you're doing anything else, I know not.  But I'm always open to
enlightenment.

[Parker_021]

It appears that the issue was that i had to remove the id and password. Once that was done it automatically updated the remaining settings.