Daily Reboot of R7900p

[Barvel-A]

Hello,

I have had my router in place for 3 weeks and now daily, if not x2 or x3 I have to power down for 10-15 min.

in reading the threads this is not uncommon.

but I don't see a resolution with my fir East. 

Hardware R7900P

firmware Ver V1,4,1,42_ 1.3.4

Gui Ver V1,4,1,42_ 2.1.46.1

[plemans · Accepted solution]

here's what I'd try and the order

1. factory reset the router. the version you're on removed many features. don't install from backup.

2. downgrade to V1.4.1.30. do it over a hardwired connection and reset the router afterwards. Again, don't install from backup. 

[plemans · Accepted solution]

here's what I'd try and the order

1. factory reset the router. the version you're on removed many features. don't install from backup.

2. downgrade to V1.4.1.30. do it over a hardwired connection and reset the router afterwards. Again, don't install from backup. 

[michaelkenward]

---

@Barvel-A wrote:

Hello,

I have had my router in place for 3 weeks and now daily, if not x2 or x3 I have to power down for 10-15 min.

---

Why? What is happening that prompts you to do this?

It might also help if you told people what the modem is in front of this router, if there is one. The model number could be useful. Is it, by any chance, also a router, with a set of LAN ports on the back?

The reason for asking is that a lot of people turn up here trying to put a router behind a modem that is also a router.

[Barvel-A]

Thank you @plemans .That worked. I have NOT had to force a reboot since the Down Grade. 
Not to happy about not being current.  But less happy with it not working.

[Barvel-A]

I spoke to soon.
This morning I had to reboot and just now I had to do it again. 

@plemans  Any other options.

[Barvel-A]

@michaelkenward Thanks for that. 
I have been doing this for 30+ years and that is a rookie move putting the modem on the wrong side.

There are no prompts.  It just stops.

There is nothing in the event logs to refer to after the reboot because they are wiped. 

I did see this after my reboot;

[DoS attack: ACK Scan] from source 198.255.6.34,port 21047 Thursday, Feb 06,2020 21:28:07

But those are common to any router.  Some one is always trying to hack in.

---

[michaelkenward]

---

@Barvel-A wrote:

I did see this after my reboot;

[DoS attack: ACK Scan] from source 198.255.6.34,port 21047 Thursday, Feb 06,2020 21:28:07

---

IP Addresses Report

Created by using IPNetInfo

Order	1
IP Address	198.255.6.34
Status	Succeed
Country	USA - California
Network Name	FOSCAM
Owner Name	ShenZhen Foscam Intelligent Technology Co., Ltd
From IP	198.255.6.32
To IP	198.255.6.39
CIDR	198.255.6.32/29
Allocated	Yes
Contact Name	ShenZhen Foscam Intelligent Technology Co., Ltd
Address	Room AB 9/F Block F5 TCL International E City No. 1001 Zhongshan Shenzhen
Postal Code	518055
Email	support@foscam.com
Abuse Email	support@foscam.com
Abuse Contact
Phone	+86-755-26745668
Fax
Whois Source	ARIN
Host Name
Resolved Name

[ValricoJoe]

Good luck getting this to stop happening, based on my fighting with two of the units, hours wasted on tech support, I took them back and got a refund, looking to suppliment my FIOS Aeris router, just have not found a replacement yet.

Good luck setting static ip addresses and locking down the router, after a couple dozen times or having to set up the router, I gave up, took all of them back to Costco.  Look at the threads on this POS, all have the same problems and Netgear has not resolved.

[Barvel-A]

@ValricoJoe 

@michaelkenward 

& @plemans 

I gave up. 🤷🏽‍♂️

I went and got a Nighthawk AX12 and tosed the other system in the 🗑.

Thank you all for your help.