How do I get rid of Arlo

[Chaos0320]

 I just updated my Nighthawk R7000 to Firmware Version
V1.0.4.30_1.1.67 and now Arlo is on my internet and I dont know how to disable it if you could please tell me how to get rid of Arlo.

Also I would also like to know how to set how much bandwidth an indivual device can recieve because I want to set my PS4 to Highest and my phone to lowest and other devices on my internet.

Thank you for your time

[TheEther]

---

@Chaos0320 wrote:

 I just updated my Nighthawk R7000 to Firmware Version
V1.0.4.30_1.1.67 and now Arlo is on my internet and I dont know how to disable it if you could please tell me how to get rid of Arlo.

Perform a factory reset.

---

Also I would also like to know how to set how much bandwidth an indivual device can recieve because I want to set my PS4 to Highest and my phone to lowest and other devices on my internet.

You cannot control the exact amount of bandwidth an individual device may receive.  You can only set the priority.

[Retired_Member]

Factory reset to defaults for arlo

[Chaos0320]

How do I change the priority for it 

[TheEther]

Arlo should not be in 1.0.4.30, so a factory reset should remove it.

[Retired_Member]

---

@Chaos0320 wrote:

How do I change the priority for it 

---

Read chapter 4

http://www.downloads.netgear.com/files/GDC/R7000/R7000_UM.pdf