- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Netgear Nighthawk D7000 SNMP support for MRTG
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI Folks
I just replaced my old TPlink 1043ND and 8840T DSL modem with this D7000. Is there special menu to enable snmp on this modem/router combo.
Below what I used to get on my old Tplink 8840T. Everytime I run MRGT config its fails. Does this DSL modem actually support SNMP?
I
rgds
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks you are right no DD-WRT for D7000 ADSL/VDSL modem. definitly not a R7000. Well let see if a port for D7000 turns up in the database.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Netgear Nighthawk D7000 SNMP support for MRTG
I never knew the D7000 existed. Anyway, I think you are out of luck. I'm pretty sure that SNMP is not supported on stock firmware.
If you had a R7000, you could switch to 3rd party firmware, like DD-WRT, which supports SNMP.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks you are right no DD-WRT for D7000 ADSL/VDSL modem. definitly not a R7000. Well let see if a port for D7000 turns up in the database.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more