- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Nighthawk X10 R9000 is stuck with 60Ghz after fw upgrade 1.5.0.36
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nighthawk X10 R9000 is stuck with 60Ghz after fw upgrade 1.5.0.36
@ links to members
My 2.4Ghz and 5Ghz stopped working after fw upgrade. I tried all sorts resetting to default and then fw upgrade downgrade. Turning wifi on /off but no luck. Any body experiened such problem. Need help stuck with this issue
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Nighthawk X10 R9000 is stuck with 60Ghz after fw upgrade 1.5.0.36
turning wifi on/off but pushing and holding the button for 2 seconds? or by trying it in the gui?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Nighthawk X10 R9000 is stuck with 60Ghz after fw upgrade 1.5.0.36
I tried those option but hard pressing wifi on /off on router and then also doing via. GUI. something weird It just got stuck with 60Ghz. Currently setup i have spectrum cable modem connected over gig to this X10. It worked when internet was setup. but something weird happened after fw upgrade. I did factory reset. downgrade to .28 and then .26 and .24 and finally got back to same as .36. For now I got tired took away all the cables and power cord.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Nighthawk X10 R9000 is stuck with 60Ghz after fw upgrade 1.5.0.36
are there any known issues with these X10. Im losing trust with Netgear products.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Nighthawk X10 R9000 is stuck with 60Ghz after fw upgrade 1.5.0.36
Devices do fail. it does happen.
Are you still within your warranty?
After you changed firmware (downgraded) did you factory reset?
Are you reinstalling from a backup configuration? If so, try a clean install (not using a backup).
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Nighthawk X10 R9000 is stuck with 60Ghz after fw upgrade 1.5.0.36
Devices do fail. it does happen. Yes I get that but all of sudden that too after fw upgrade is scary.
Are you still within your warranty? No
After you changed firmware (downgraded) did you factory reset? yes I did that too.
Are you reinstalling from a backup configuration? If so, try a clean install (not using a backup). no i didnt take any backup configuration. As I was ok in reconfiguring. after doing factory reset. I did try with fw upgrade in reverse order .28 .26 and .24 and nothing worked then i tried reupdating back to .36 What is weird configuration changes either GUI or pressing wifi disable/enable too only locks up 60Ghz but doenst let 2.4/5 Ghz enabled back. I feel something fw code screwed up. locking up antenna or channels
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more