Reply

Nighthawk model r6400 does not show all WiFi networks

Noalv
Follower

Nighthawk model r6400 does not show all WiFi networks

Hello
I installed a new router in my home. Netgear r6400. Beside the fact that it was a nightmare to install it.
After i finally managed to connect the aop to my router. The app occasionally does not show all the devices that are connected to the networks. Sometimes it does not show the 2.4ghz network and sometimes it does not show the 5ghz network. Only after a reset of the router, the networks shows up again, for a few minutes or hours, and when i refresh the page of the devices again, one network again, disappear and i have to do reset to the router again.
What is the solution to this problem?
Thanks
Model: R6400|AC1750 Smart WiFi Router
Message 1 of 2
FURRYe38
Guru

Re: Nighthawk model r6400 does not show all WiFi networks

Please post about this here for your model router:
https://community.netgear.com/t5/General-WiFi-Routers-Non/bd-p/home-wifi-routers-general

Good Luck. 

My Setup Internet Cable 1000↓/50↑ CAX80 Mode Mode | ISP SparkLight | Wifi Router Orbi CBR752 v4.6.7.7(Gateway Mode), Wired BackhaulSwitches Netgear GS105/8 | 

Additional NG HW: C7800/CM1100/CM1200/CM2000, Orbi CBK40, CBR750, RBK953(v6.0.3.68) & XR450(v130), RBK853 v4.6.7.5(AP) & RBK752 v4.6.7.5, RBK50(v23), SXK30(v110), R7000(v34), R7800(v84), R7960P(v84), RAXE500(v78), EX7500/EX7700, GS308v3 and WNHDE111


 


 


Testing

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 112 views
  • 0 kudos
  • 2 in conversation
Announcements

Orbi WiFi 6E