R7000 & TunnelBroker IPv6 Setup

[88keyz]

I don't know if its even possible but if anyone out there knows of a good walk-through tutorial on how to setup the stock firmware on the R7000 for a Hurricane Electric/TunnelBroker 6in4 IPv6 tunnel I would appreciate any help you can provide. Using stock firmware 1.0.4.28 in case that helps or matters.

I've setup TunnelBroker IPv6 tunnels on other routers (OEM, Tomato, DD-WRT) but I can't seem to figure out the setup on the R7000. Nothing I try seems to work so I'm beginning to think its not possible. I realize I could flash DD-WRT or Tomato onto the R7000 but I've found that my wireless range isn't as good with third party firmware. In addition without the CTF hardware acceleration I can't max out the downstream my 300D/20U internet connection so I'm really looking for a solution using the stock firmware.

Thanks in advance for any help or suggestions you can provide.

[Metshrine]

Have you had any luck? I am having problems getting a tunnelbroker.net /64 configured on the R7000. The linksys EA9200 was easy to do but I cannot figure out the R7000.

[RealRedHair]

Having the same problem. See https://community.netgear.com/t5/General-WiFi-Routers/How-to-configure-IPv6-using-tunnelbroker-net/t... for general instructions. You have to enable ping as well. Does it work for you people. Before it worked for me with Miredo and Tuntap. See also http://www.deepdarc.com/miredo-osx/ but it is a bit outdated.