Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
RN102 power led keeps blinking after firmware update
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-02-19
05:20 AM
2018-02-19
05:20 AM
RN102 power led keeps blinking after firmware update
After bringing the V1.3.0.20_10.1.1 down and installing it, during the restart, the power light began flashing and I could no longer get the device to load. Is there a way to restore the firmware or does anyone else have suggestions?
Model: R7000P|Nighthawk AC2300 Smart WiFi Router with MU-MIMO
Message 1 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-02-23
04:46 AM
2018-02-23
04:46 AM
Re: RN102 power led keeps blinking after firmware update
The ReadyNAS RN102 uses 6.x firmware versions, not V1.3.0.20_10.1.1
Are you having this issue with your Nighthawk Router?
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-02-23
08:57 AM
2018-02-23
08:57 AM
Re: RN102 power led keeps blinking after firmware update
That is correct - it was the nighthawk router. After the update, the power light went red and continually flashed even after discnnecting the power and plugging it back in.
Message 3 of 3