- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: USB Control Center Freezing on Installation and/or Removal
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm trying to download the USB Control Center, I'm running Windows 10 Pro N. Everytime I install, it freezes at the same point. When I try to repair or install, it also freezes. I installed it on another computer and works great.
I have having to do a hard reboot when this happens.
I have the most current firmware installed.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So apparently I had a bad installation that was causing problems. I downloaded IObit Uninstaller which completely scraped off the bad install and then tried a fresh install. Works great now.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB Control Center Freezing on Installation and/or Removal
@ScoWeazy wrote:
I'm trying to download the USB Control Center,
What's that? The ReadySHARE Printer utility?
There is support material, including a manual and any additional software, for the R7000 somewhere at the end of this link:
>>>> R7000 | Product | Support | NETGEAR <<<<
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB Control Center Freezing on Installation and/or Removal
This doesn't sound like a Router problem? However, if it is a program (unknown what USB Control Center means?) then your PC is the problem. Check the Event Viewer for some hints...
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB Control Center Freezing on Installation and/or Removal
Yes, the readyshare printer utility.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB Control Center Freezing on Installation and/or Removal
@IrvSp wrote:
(unknown what USB Control Center means?)
That threw me too.
Go look at the Readyshare controls in the browser interface, then ReadyShare Printer:
Step 3: On each computer that will share the printer, download the NETGEAR USB Control Center utility from http://www.netgear.com/readyshare.
Unfortunately, even when you visit the link you are left not much wiser. Heaven only knows which of the various bits there counts as the "Control Center".
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: USB Control Center Freezing on Installation and/or Removal
If the utility is the one on this page, it seems to be out of date and limited to the number or routers supported.
ReadySHARE: Your Router Can Do Everything | NETGEAR
The R7000 is in there.
Is that the software you ran? It installed here in Windows 10 Pro 64 bit.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So apparently I had a bad installation that was causing problems. I downloaded IObit Uninstaller which completely scraped off the bad install and then tried a fresh install. Works great now.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more