- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
USB Not Auto-Mounting After Power Cycle.
I have a SanDisk USB3 64 Gig Thumb drive plugged into the USB3 port on the rear of my router.
Everything works perfectly fine as long as I do not powercycle my router.
If I powercycle the router (after a configuration change or an update) the USB does not mount automatically.
All I have to do is unplug the thumb drive and re- plug-in the drive and it mounts fine and is almost immediately accessable.
My Question is:
Is there a way to have the drive auto-mount after a powercycle?
Or is this just a "Feature" that I will have to wait for a fix sometime down the road.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Re: USB Not Auto-Mounting After Power Cycle.
@Cynyster wrote:All I have to do is unplug the thumb drive and re- plug-in the drive and it mounts fine and is almost immediately accessable.
My Question is:
Is there a way to have the drive auto-mount after a powercycle?
Or is this just a "Feature"
that I will have to wait for a fix sometime down the road.
Thanks
Welcome to the 'club'. Yup, from V1.0.4.28 and possibly the last f/w, this happens. I've got a 2TB external drive and it happens to it, but not all the time. I even have it happen on a re-boot via the GUI router page. I'd say 75% of the time I need to unplug/plug it back in. It always picks up immediately.
Maybe mine works 'more' because it is self-powered vs. a flash drive that isn't.
User | Count |
---|---|
48 | |
21 | |
13 | |
10 | |
9 |