- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Upgraded router to Nighthawk R7000 and now my VueZone GW2010 & cameras won't connect
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I just recently upgraded my router to the Nighthawk 7000 and I have the older model Vuezone base station (GW2010) with 5 cameras for home security. I have gone through all the basic troubleshooting suggestions and I just can't get the base station to connect with the new router. Everything else in my home is working beautifully with the new router and I also invested into a new battery backup/surge protector for my home office equipment because we have had some construction going on down the road and have experienced a few power blips on and off lately. I'm thinking I'm gonna have to upgrade to an Arlo based system to get it working even though I was hoping not to have to spend anymore $$$ on this for home security. I really loved my vuezone and I hope this isn't built-in obsolence with my basestation and cameras. Thank you for you comments in advance. Candice
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded router to Nighthawk R7000 and now my VueZone GW2010 & cameras won't connect
I have the same issue, went through three different "support" persons, got case numbers. The second person told me to call back after my last attempt to flash the firmware. If it failed, they would replace the unit. It failed, I called back. Got a very rude punk who refused to send a replacement. Asked for his supervisor. They would not get on the phone, but refused, as well. I paid $700.00 for the thing and I swear I will NEVER buy another Netgear product. I have 2 extenders ($150 each). SO mad at them. Do NOT buy their product! Dropping wifi is a known problem to them and the guy I got was an az!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded router to Nighthawk R7000 and now my VueZone GW2010 & cameras won't connect
For clarity, the issue is getting the base station to connect with the router and not viewing the camera from web?
Can you go through some of the steps you've taken thus far so someone doesn't recommend something you've already tried?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded router to Nighthawk R7000 and now my VueZone GW2010 & cameras won't connect
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded router to Nighthawk R7000 and now my VueZone GW2010 & cameras won't connect
Perhaps, you may want to try to check out the link below.
VueZone Base Station Offline/Not Connected – System Was Previously Working
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded router to Nighthawk R7000 and now my VueZone GW2010 & cameras won't connect
Thank you for the update.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more