This is for Nighthawk X10 R9000 not 7200.
When I try to use access control or see connected devices the pages load and then produce a balnk page upon completion. I set up the router and blocked new devices now I cant undo that to allow a new one because the page wont load. Any suggestions besides a factory reset. That would be a lot of work which Im not really a fan of.
Solved! Go to Solution.
Re: access control
Don't know about the r9000, but Voxel fixed the blank device screen for the r7800.
I would give his firmware a try. Installs just like doing a manual upgrade/downgrade of OEM firmware and looks the same.
Link to Voxel firmware.
ISP Comcast, Modem-Netgear CM1150V, Router-Unifi Security Gateway-Pro4, AP-2 Unifi AP-LR
Tesla > Edison