- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
access control
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is for Nighthawk X10 R9000 not 7200.
When I try to use access control or see connected devices the pages load and then produce a balnk page upon completion. I set up the router and blocked new devices now I cant undo that to allow a new one because the page wont load. Any suggestions besides a factory reset. That would be a lot of work which Im not really a fan of.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We are working on the issue for the attached devices on the R9000.
DarrenM
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We are working on the issue for the attached devices on the R9000.
DarrenM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: access control
Has this issue been solved yet? It has caused me lots of problems for a very expensive router
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: access control
Don't know about the r9000, but Voxel fixed the blank device screen for the r7800.
I would give his firmware a try. Installs just like doing a manual upgrade/downgrade of OEM firmware and looks the same.
Link to Voxel firmware.
https://www.voxel-firmware.com/Downloads/Voxel/html/index.html
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more