Reply

Re: access control

overbet
Aspirant

access control

This is for Nighthawk X10 R9000 not 7200.

 

When I try to use access control or see connected devices the pages load and then produce a balnk page upon completion. I set up the router and blocked new devices now I cant undo that to allow a new one because the page wont load. Any suggestions besides a factory reset. That would be a lot of work which Im not really a fan of. 

Model: R9000|Nighthawk X10 AD7200 Smart WiFi Router
Message 1 of 5

Accepted Solutions
DarrenM
Sr. NETGEAR Moderator

Re: access control

We are working on the issue for the attached devices on the R9000.

 

DarrenM

View solution in original post

Message 2 of 5

All Replies
DarrenM
Sr. NETGEAR Moderator

Re: access control

We are working on the issue for the attached devices on the R9000.

 

DarrenM

View solution in original post

Message 2 of 5
Firefox473
Initiate

Re: access control

Has this issue been solved yet?  It has caused me lots of problems for a very expensive router

Message 3 of 5
myersw
Master

Re: access control

Don't know about the r9000, but Voxel fixed the blank device screen for the r7800. 

I would give his firmware a try. Installs just like doing a manual upgrade/downgrade of OEM firmware and looks the same. 

Link to Voxel firmware.

https://www.voxel-firmware.com/Downloads/Voxel/html/index.html

--Bill
ISP Comcast, Modem-Netgear CM1150V, Router-Unifi Security Gateway-Pro4, AP-2 Unifi AP-LR
Tesla > Edison
Message 4 of 5
overbet
Aspirant

Re: access control

Sorry no, I ended up doing a reset. 

Message 5 of 5
Top Contributors
Discussion stats
  • 4 replies
  • 902 views
  • 2 kudos
  • 4 in conversation
Announcements

Orbi WiFi 6E