This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
Been thinking about setting up my rax80 router and my cm1200 modem for multi gig. Do I need to setup ethernet port aggregation before internet port aggregation? I'm a little comfused on the issue. Also would it make any difference to do the setup because my service is 1.2G?
Do you pay for 1.2gig service? If not, I'd follow @microchip8 advice and leave it.
If you do, then what I've done prior is this.
have the browser open with a tab for both the modem and one for the router.
then I enable it in the modem. While its rebooting, I then enable it in the router and connect the 2x ethenet connections between the router/modem.
Usually works. Every once in a while when I do it, i have to power off the modem and router for 2 minutes, then power them back on (modem first, give it a couple minutes, then turn on the router). I haven't had any issues doing it this way.
Do you pay for 1.2gig service? If not, I'd follow @microchip8 advice and leave it.
If you do, then what I've done prior is this.
have the browser open with a tab for both the modem and one for the router.
then I enable it in the modem. While its rebooting, I then enable it in the router and connect the 2x ethenet connections between the router/modem.
Usually works. Every once in a while when I do it, i have to power off the modem and router for 2 minutes, then power them back on (modem first, give it a couple minutes, then turn on the router). I haven't had any issues doing it this way.
