My R9000 went down a few weeks ago and Netgear sent me a remanufactured AX80 replacement.We won't go back through all of the issues that caused, but I have found work arounds for nearly all of the other issues but this. Internet drop outs on a hard wired connection. I tried anouther brand new cable modem and a fresh install of Chrome to eliminate those two factors, but I am still seeing a steady stream of drop outs as indicated by the attached logs.
Any ideas since Netgear support will not respond to the support ticket anymore?
Current setup: CM2000-> RBE973S-> Trendnet TEG-S380-> GS716T-> pi-hole also in AP setup: RAXE500->EAX80 1.4gig download/100mbps upload from Xfinity We’re members of the public helping out on our own time.
After the firmware change did you attempt a factory reset?
Also the SB8200 has 2x ethernet ports but only 1 is usable for the average user. Make sure only 1 device is connected
Current setup: CM2000-> RBE973S-> Trendnet TEG-S380-> GS716T-> pi-hole also in AP setup: RAXE500->EAX80 1.4gig download/100mbps upload from Xfinity We’re members of the public helping out on our own time.
Yes, only one WAN port is connected on the SB8200. And yes, I have booted, reset, and reconnected this router by every means known to man over the last two weeks. Netgear does not respond to the support tickets, nor explain why I was sent a remanufactured AX80 to replace the original R9000 I bought. I am done with Netgear. My next boot will be any product with the Netgear logo out of my network. I got fed up yesterday and ordered a new tri-band wifi6. Routers should not be this hard, especially when customer support is non-existant. Thanks for you suggestions my friend. Netgear has burnt this bridge.
