- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: CAX80 turn off IPV6 and port forwarding
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CAX80 turn off IPV6 and port forwarding
Is there a way to turn off IPV6 on this router? Also im trying to forward port 8003 so i can see my Cameras outside of my network and its saying the port is already being used. I looked at UPNP and it showing port 8003 being used. so i turned off UPNP on my NVR and then tried to forward the port again and it still saying its being used. Someone please help
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: CAX80 turn off IPV6 and port forwarding
IPv6 should be under Advanced Tab/Advanced/IPv6.
Netgear has set up a community forum specifically for the Cable Modem products. Most of the people who watch that forum are more likely to have experience with Cable modems:
https://community.netgear.com/t5/Cable-Modems-Routers/bd-p/home-cable-modems-routers
Please use this link to the main forum product list to review and choose where to make your posts.
https://community.netgear.com/t5/NETGEAR-Forum/ct-p/en-netgear
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: CAX80 turn off IPV6 and port forwarding
Thank you, i was able to get open the Ports with UNP but i had to change my Routers IP address a bit. I will post over in the other section
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more