- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: EAX80
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
EAX80
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: EAX80
do you have it setup in mesh mode? (onewifi)
If so, it uses the same ssid as the router so it won't show up as a seperate network.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: EAX80
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: EAX80
I prefer mesh mode as its simpler. Devices will band steer between 2.4ghz and the 5ghz band and switch from extender back to the router as needed.
If you just got the RAX200, did you have to reinstall the EAX80?
Did you set it up using wps? If so, the default setup is using mesh/onessid.
You can log into the RAX's attached devices page and get the ip address or view if the extender is attached.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: EAX80
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: EAX80
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: EAX80
to know if its switching between 2.4ghz/5ghz you can check the devices connection status.
It should tell you 2.4/5
I've found that it takes a little bit until the router/extender learn which device belongs on which band.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more