Fowarding multiple ports on RAX50

[din_dawn]

I am not able to foward multiple ports within a service.

For example, if I enter "21, 80, 500, 5000-5001" and apply, only port 21 is forwarded (Pic 1 &2 is what I entered and what actually applied).

My firmware version is V1.0.5.106_2.0.70, is there any solution to fix it? Thanks.

[plemans]

does it work if you just add a couple and not the whole range? (for testing)

Or are you able to go back in and modify it? 

[din_dawn]

I found out that I can foward a range of ports (eg. 1-100), but not putting different ports with comma. The problem remains if I go back to modify it. Thanks you help though

[plemans]

kind of a PITA but if you can add them individual it could work. 

Luckily you don't have a ton. 

Once you've done so, I'd make a backup configuration. That way if you ever factory reset, you can restore the port forwarding easier. 

[din_dawn]

That's the ports I needed lol.

Sure I will make a backup for this, hope Netgear engineers will fix it in the future.

[plemans]

hope you don't need to use the backup but glad the work-around works. 

[Razor512]

Try using just single values separated by a comma rather than a combination of single values and ranges in one entry. If it doesn't work then it could be a UI related bug.

[KB2MXV]

Any update on this issue?  I'm in the same boat with the RAX50.  My older R7450 works as expected

[LincolnOtter]

Same issue here. Looks to be a UI bug. Form strings not being parsed correctly.

Firmware Version V1.0.11.112_2.0.77