NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Netgear CM1200 to Rax200 WAN aggregation not working ?
Hi guys. Sorry for my bad english. I'm trying to connect my CM1200 with RAX200 using WAN aggregation. I'm following steps according to guidelines from the instruction and so far after a week of mu...
Here is Video of whats happening:
https://drive.google.com/open?id=1JmnpHlFFAYLITFjzE89tIAh5-Y1_eMc5
It looks like your RAX200 is doing a continuous loop and if that is correct it should not be doing that. You can try doing a hard reset on the RAX200 and see if that helps resolve the issue.
How do I perform a factory reset on my NETGEAR router?
and or if that does not work save a debug log and contact support and maybe the debug log will help them locate the issue better.
Note: After you Start the Debug capture try to setup Milti-Gig internet and when the RAX200 starts continuous loop Save the Debug log.
Also if it does not allow you to save the Dubug Log because it is looping then just click the Start Capture and then Save the Debug Log so you at least have something to give to Support.
Thank you for helping me out. I did start and save debug log. on the proces to upload to support. i dont know if is wise to upload debug to forum for security resons. Thank you again for you help i will post everything what i will get from support.
wonderfull , glad I could help and I hope it gets resolved.