NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Nighthawk x10[R9000] To Nighthawk Tri-Band AX12[RAX200]
So I upgrade from R9000 to RAX200 Router, I was hoping to see at least 10% Wi-Fi speed improvement but seen none!!! I got Verizon Fios Gigabit speed but surprise to see no improvement over the previo...
I see you are running the latest firmware on your RAX120. Does the RAX120 now have the option to aggregate the LAN port that's next to the WAN port for dual WAN capability?
kc6108 wrote:
Does the RAX120 now have the option to aggregate the LAN port that's next to the WAN port for dual WAN capability?
Just to avoid confusion - even if there are aggregation options to combine two GbE LAN ports as a WAN port (trunk, LAG, ...e.g. to connect one of these advanced Netgear cable routers/modem also supporting aggregation because these allow traffic > 1 Gb/s - it's still a single WAN.
- Sorry. That was bad word choice on my part. I just want to know if Netgear has added support for multi-gig Internet speeds on the RAX120. I know the RAX80 has since launch.
Redtulips7 can you please brefly check is your RAX120 Basic Internet-Setup does show the "WAN aggregation (1 Gbps + 1 Gbps)"
radio button in the WAN Preference section?
schumaku wrote:
Redtulips7 can you please brefly check is your RAX120 Basic Internet-Setup does show the "WAN aggregation (1 Gbps + 1 Gbps)"
radio button in the WAN Preference section?WAN Preference
