This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
My RAX80 runs on firmware v1.0.3.98_1.0.46. Router status shows time from 14 days ago. reloading page shows the same time plus few seconds but minutes never advance. NAT was configured to use default NETGEAR time servers, I changed that to use time.google.com and rebooted router. Correct day and time appeared upon reboot but then the minues would not advance again. Any suggestions?
My RAX80 runs on firmware v1.0.3.98_1.0.46. Router status shows time from 14 days ago. reloading page shows the same time plus few seconds but minutes never advance. NAT was configured to use default NETGEAR time servers, I changed that to use time.google.com and rebooted router. Correct day and time appeared upon reboot but then the minues would not advance again. Any suggestions?
I sent a private message to @Christian_R with my serial number & email address. I was sent the beta firmware which has solved the NTP Router Time Issue and ipV6 connectivity.
My RAX80 runs on firmware v1.0.3.98_1.0.46. Router status shows time from 14 days ago. reloading page shows the same time plus few seconds but minutes never advance. NAT was configured to use default NETGEAR time servers, I changed that to use time.google.com and rebooted router. Correct day and time appeared upon reboot but then the minues would not advance again. Any suggestions?
I sent a private message to @Christian_R with my serial number & email address. I was sent the beta firmware which has solved the NTP Router Time Issue and ipV6 connectivity.
@SAM_the_GAM thanks for your advice. I received a beta firmware and it seems that some time issues are resolved and some aren't. Logs show correct time now.
