NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAX80 latest firmware V1.0.3.98_1.0.46 breaks router TIME
Today I upgraded the RAX80 to V1.0.3.98_1.0.46 This seems to have broke the system time on the router. It's is in an continous loop of about 1 min based on the time it gets after a reboot. Th...
Yes, that's the very same problem. Also several different devices are listed as using the same IP.
I can't tell you how many hours I've spent doing factory resets and then running around getting some fussy smart devices to reconnect again.
From bad to worse. Router died at 1:10am, could not access any interface, stopped routing traffic. I rebooted and it started routing traffic again but cannot connect on any (192.168.1.1, routerlogin.net, nighthawk app) interface. Browsers say the device is not responding, using both safari and chrome. I have a support case (43161461) started because I purchased the router March 29,2020 but it registered as Nov 29,2019 - which they fixed with my receipt.
I finally pulled the router (taking down my network and pi$$ing the family off) and held reset while turning it on. I find firmware V1.0.3.98_2.1.46.1 but it rebooted in the middle of reconnecting it to my network. I am requesting a router replacement. Not happy.
Apologies, I do not seem to be able to edit my above post but the language file is 1.0.3.98_2.1.46.1, the firmware was V1.0.3.98_1.0.46. I attempted to restore my settings and the router was unreachable. The router was reset, not connected to a network, with only my computer plugged into the ethernet port. Done. Can't spend any more time on this.
I updated my router to this firmware the other day as well. Since then, ALL of my wireless devices disconnected over night each night requiring a reboot (or several) of the router. Also can no longer even get to the into the router interface on web or mobile... web says the site didn't return any data, mobile doesn't find the device... I had my first RAX80 replaced because it kept dropping devices. This one seemed better until this update, now I can't even access my router to roll back the firmware. Hard reset may help, but I really don't want to have to set up all my static leases and port forwarding again.. What a complete waste of money
Jaydawgx7 yep, hard reset. Annoying, but that is usually the only way to get out of it. I've done it so many times I have developed a long procedure in my head to make sure things are back to the way they are. Causes havok with lots of devices though. I am considering moving to an asus router.