LAG for Dual WAN Orbi RBK 852

[Darkknight007]

How to setup dual wan with link aggregation from two nokia G-140W-F units

[plemans]

WAN link aggregation isn't to link 2 devices to the orbi.

its for trying to get speeds greater than 1 gig from 1 device. LIke a CM1100, CM1200, Arris SB8200. 

[FURRYe38]

You can only have 1 LAG configuration...Check the user manual for LAG setup. 

[FURRYe38]

Maybe you can have the LAG enabled and use two different ISP modems:

https://kb.netgear.com/000061324/How-do-I-set-up-WAN-aggregation-on-my-Orbi-WiFi-6-System

Let us know if you find out this works for you. 

[Darkknight007]

Have been trying to setup the LAG/LACP(Step 7) for Nokia G-140W-C & Nokia G-140W-F however not sure how did one achieve dual wan. I have two different ISPs connected to thes modem+router units

[plemans]

I don't have a RBK852 but my understanding was the WAN port aggregation was single device usage.

Otherwise you'd have the options of load balancing/fail-over like a dual wan router and not a wan port aggregate router. 

i sure could be wrong. 

@Christian_R 

[FURRYe38]

First off, try LAG with just one modem if that one modem supports LAG as well. Your modem has to support LAG. 

---

@Darkknight007 wrote:

Have been trying to setup the LAG/LACP(Step 7) for Nokia G-140W-C & Nokia G-140W-F however not sure how did one achieve dual wan. I have two different ISPs connected to thes modem+router units

---

[schumaku]

---

@plemans wrote:

... my understanding was the WAN port aggregation was single device usage.

Otherwise you'd have the options of load balancing/fail-over like a dual wan router and not a wan port aggregate router. 

---

Perfectly correct.

@Darkknight007 there is no support for operating multiple WAN connections or multiple WAN devices on any Orbi.