- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Prepurchase question - Orbi Pro setup on existing network
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Prepurchase question - Orbi Pro setup on existing network
I would like to set up a mesh wifi connected to our existing office & light manufacturing network. Our current system is:
two fiber ISPs connect to:
1 - microtik router which splits off VOIP to phone system and data to Meraki firewall
2 - directly to Meriki firewall
Meraki firewall functions as router, DHCP server and of course firewall. Also failover between the two fiber sources.
from firewall, data goes through HP managed switch to wired network.
Can I set up an Orbi system connected to this network to create mesh wifi behind the firewall? I tried with another maker's home system and was unable to complete a setup that would work using the admin interface it provided so I want to confirm I can do this prior to making another purchase?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Prepurchase question - Orbi Pro setup on existing network
You should be able to.
I've ran my SXK30 in access point mode attached to my current network.
And it worked fine.
I say *should* because stranger things have happened than a firewall/other router caused issues.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Prepurchase question - Orbi Pro setup on existing network
Not sure exactly what you mean by "parent" "child" nodes.
I've ran it in AP mode connected to the following: arris w31, Orbi RBK53, and a CAX80.
Just to test them.
I had the SXR hardwired in and then the SXS both hardwired and wireless (to test).
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Prepurchase question - Orbi Pro setup on existing network
@plemansI think that clarifies it for me, thanks very much. I was forgetting that the Orbis have different models for the router and the satellites. I was using terminology that came from a Linksys system. It sounds like at least it could work.
Noobie questions - Does anyone from Netgear monitor the forum? Am I likely to get a more definitive response from them here? (I understand completely your caveat about Stranger Things happening)
And, if I mark your answer as Accept as Solution, does that close the thread?
Thanks again.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Prepurchase question - Orbi Pro setup on existing network
If you mark it solved, it doesn't close the post but it does tend to get less attention.
Then tend to be a little more active on the business forum/devices versus the consumer forums.
Maybe a mod will appear....:)
@BretD @DavidGo @hnagaraju @DarrenM