- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: SXR80 Firmware 4.0.0.118 Update Fails on Satellite
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Trying to update SXR80 firmware from V3.0.0.208 to V4.0.0.118.
I tried automatic update, and the router downloaded the update, but did not apply it. Satellite did not download. So I went manual.
Manual upload of firmware to router worked fine, and router updated, but Satellite did not. Every time I try, Satellite reports:
"This firmware file is incorrect! Please get the firmware file again and make sure it is the correct firmware for this product."
But it is the same firmware file I used to update the router, which worked just fine.
Guidance appreciated!
David
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @rdhull
For SXS80 please use the following https://www.netgear.com/support/product/sxs80.aspx#SXS80%20(Orbi%20Pro%20Satellite)%20Firmware%20Ver...
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @rdhull
For SXS80 please use the following https://www.netgear.com/support/product/sxs80.aspx#SXS80%20(Orbi%20Pro%20Satellite)%20Firmware%20Ver...
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: SXR80 Firmware 4.0.0.118 Update Fails on Satellite
Never mind. I was uploading the SXR80 firmware, instead of the SXS80 firmware. :catsad: