NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
New - RBR750 / RBS750 Firmware Version 7.2.6.21 Released
New Features: 09/08/2023
Supports Separate SSID IoT network.
https://kb.netgear.com/000064267/How-do-I-enable-or-disable-the-Internet-of-things-IoT-network-on-my-Orbi-WiFi-6E-System
https:/...
Followed the directions and upgraded. Did the RBS750 units first and then the RBR750. Appears to be working well.
One important note, I did need to restart each RBS750 after the RBR750 was upgraded to re-establish connection. As each is on a UPS and mounted on the all, required a ladder.
Otherwise working fine at this time.
I didn't see the "IoT" network feature at first. You need to go into Wireless setup. You'll then see a "Wireless IoT Settings' and the ability to "enable" an IoT wireless SSID along with password.
Nice to have this feature added finally. I believe it's important to have a Trusted, IoT and Guest wireless SSID.
I would bring the RBS to same room and the RBR and connect the RBS to the RBR while in same room wirelessly first. Test and check stats. Then ethernet connect the RBS to back of RBR using good quality CAT6 cable. Check the stats on the RBR. Should see 1000Mbps here.
As stated in the intial post, a power cycle of the system is recommended after the FW update.
If problems are seen, a factory reset and setup from scratch maybe needed.
Foutiti67 wrote:
Hello i know what is the problem, in the statistic, the connection between rbr and rbs is only at 100M .
Beforce the update with the same configuration (cat7 rj45) is was at 1000m .
What appen ? ( i do reset of all device and it is the same ..)
thx all
