NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Orbi RBK852 4.6.3.16 broken (Solved)
This topic is only for the Netgear Orbi RBK852 / RBK853 / RBK854 / RBR850 Introduction: I bought my Netgear Orbi RBK852 last year. It's work fine and I am happy with that until they release 4.6...
- Especially with Netgear, always do a "Pin Hole Reset" after a "New Version Update" and input the operational information by hand. NEVER use a Backup File. Especially across different versions.
Yes, of course.
If you still having warranty. Just bring the router to the repair center. In your case, the issue maybe not caused by the firmware. Maybe there are some hardware failure
- I am.not. And there was nothing wrong with the system.ubtil the last firmware update.
Good to hear new firmware is out there and appears to be working....hopefully Netgear will release to the public soon.
I loaded the unpublished version on mine yesterday. Factory reset and setup from scratch using the RBR web page. 850 in router mode. RBS ethernet connecte to the RBR via LAN switches. RBS still on v4.3.16. All is still up and running since yesterday. I downloaded two large PC games to my gaming PC yesterday. NO crashes on the RBR. WIll check to see if my 3rd gen NEST gets a low battery.
Using manual channels 1 and 40.
40Mhz only enabled.
CTS left at 64
DHCP pool set to .100 to .150
No Armor or SPC enabled.
CAX80 Cable modem in modem mode only on it's 2.5Gb WAN Port.
